20/12/2013 18:45
Setting up a walk-in tub can occasionally be a difficult job. The key concern that installers and contractors have ahead of using the job is if the walk-in tub will fit the regular US 60-inch bathtub opening and whether it will, how hard might it be to position and connect every one of the plumbing and wiring? Lots of the current walk-in tub suppliers provide products which were produced abroad and will not abide by US safety and plumbing specifications. Installing this kind of walk-in tubs could be a discomfort to both: installation technician and a home-owner. This is exactly why we motivate customers get in touch with the location just before buying their walk-in tub and verify the bathtub will likely be delivered with the necessary documents for example instructions, warranty card and plumbing related certificates. Initially, you must analyze the package for just about any damages or injuries which may have happened while in shipping. Lots of times, shipping companies do not bother taking care of their packages with proper care. Instances of damaged-during-shipping products are normally proven to walk-in tub suppliers. Therefore, it is very important be sure that your walk-in tub package will probably be covered with a shipping firm before you make a real purchase. Examining the package for just about any visible damages ought to be done before unpacking the walk-in tub. Installation technician needs to be very carefully search for any kind of dents/scratches about the package.
Despite the fact that walk-in bath tubs tend to be created from acrylic and or fiberglass, heavy-duty materials, the plumbing connections are often fragile and should be handled with caution and care. Walk in tubs will never be lifted by plumbing contacts; accomplishing this can lead to future leaks. Just before the installation, see the warranty explanation carefully. Some companies can refuse accepting the return. After you ensured that your particular walk-in bathtub is here safely and there are no visual damages, you can go on to the testing phase in which comprise of only a few basic steps. Be aware that though walk-in tubs tend to be examined on the manufacturer, plenty of times damages within the plumbing connections can occur during transporting or packaging. For a whole test from the walk-in bathtub, you will want a flat working surface and area big enough to enable accessibility walk-in tub from all of the sides in the case of a drain and leak the tub right after the testing procedure is finished.
Put the walk-in tub of your flat, evenly-leveled surface area.
Close the drain and fill up the walk-in bath tub with water.
Leave behind the walk-in tub loaded with water for 25-thirty minutes and then check out the walk-in tub and the drain for almost any leaks/damages.
Supply electric on the walk-in unit and run for 10-20 minutes and inspect for leaks if tub is jetted. If leaks persist in the unions after tightening; loosen the unions and insure the O-ring is seated properly, inspect the unions throughout the pump.
Last yet not least, make certain that all of the jets are working properly.
When the pumps are certainly not functioning, be sure that the cable is hooked up and the electric breaker's power is on.
Seeing that the bathtub is tested, proceed cellular phone preparation part. You should receive the walk-in tub completely ready for cellular phone process. Aside from the routine walk-in tub maintenance, important electrical safety precautions needs to be taken. Please clean the tub of the dust or dirt that may have accommodated during shipping, before proceeding any longer. It must have 4x leveling feet in case you are ordering a US-manufactured walk-in bathtub. Adjust the walk-in tub level appropriately.
It is essential that all leveling feet are coming in contact with the level and surface to the door system to operate properly. Equipment applied to these walk-in bath tubs needs someone specialized electrical service. Service has to be a passionate 20 amp, 120 volt service that may be GFCI protected. All electric connections should be performed by a licensed electrician in line with local electrical codes and requirements. You might be now fully prepared to install the walkin tub should you be able to pass through all of the steps we have now previously mentioned. Please talk about our installation guide for the full, step-by-step installation guide.
